Philco PCE 32614 N - Příručka (Stránka 14)

EN - 12
05/2014 Copyright © 2014, Fast ČR, a. s.
Door holder
Door stopper
Self-tapping screws
8. Remove the screw hole covers from the left side as shown on the picture below and move them to the
other side on to the uncovered holes.
9. Place the refrigerator on its back on a soft underlay. Remove part 3 and loosen screws 4. Remove parts
2 and 1.
Bottom hinge (right)
Front foot plate
Bottom part of the levelling
feet
Special self-tapping screws
Washer
Note: The washer may
stick to the bottom
part of the door.
10. Screw out the bottom hinge, turn it over and screw it on to the other side.
11. Again attach parts in 9. Change part 1 to the left side and part 2 to the right side and then secure in place
with screws 4. Finally install part 3.