Philco PCE 32614 N - Příručka (Stránka 23)

EN - 21
05/2014 Copyright © 2014, Fast ČR, a. s.
ATTENTION:
Only turn on the appliance once the gasket seal is thoroughly dry.
Replacing the light
WARNING:
The light must be replaced by a service technician or qualifi ed person! If the LED light is damaged,
please contact an authorised service centre. To replace the LED light, proceed as follows:
1. Disconnect the appliance from the power socket.
2. Remove the light cover.
3. Pull out the light connector.
4. Screw out the light screws and replace the light with the same type.
5. Return the cover and connect the connector.
6. Return the light cover.
Taking out of operation for an extended period
If you are not going to be using the refrigerator for an extended period of time, do the following:
Disconnect the refrigerator from the power source by pulling it out of the power socket. Clean out the inside
and dry it out as described in the part Cleaning the refrigerator. Leave the door open to prevent an unpleasant
odour forming inside.
Please be aware:
Compressor
The compressor is controlled by the thermostat, which is set by the temperature dial, and turns itself on
automatically when temperature inside the appliance is exceeded and then turns itself off as soon as it again
reaches this temperature.
When any compressor – cooling system is turned on – noise can be heard. These sounds are made when the
motor in the compressor is working and they are also made by the coolant circulating in the circuit of the
cooling system. These noises are normal and do not indicate any malfunction in the operation of the appliance.
In unheated rooms or in cold weather conditions condensate may form on the exterior walls of the appliance.
This does not indicate a malfunction and this condensate will disappear as soon as the temperature rises.
Contact the service department only when, after analysing all possible factors of the malfunction, you
cannot fi nd any cause for the malfunction or you are unable to remedy the malfunction yourself. So, fi rst focus
on: " What should I do when...."