Philco PCE 32614 N - Příručka (Stránka 24)

EN - 22
05/2014 Copyright © 2014, Fast ČR, a. s.
PART 7: WHAT SHOULD I DO WHEN...
If you notice problems with your appliance or if you fi nd that the appliance is not working properly, you can
remedy some of the most common faults yourself prior to contacting an authorised service centre. Check the
appliance and proceed according to the instructions below before contacting an authorised service centre.
WARNING:
Do not attempt to repair the appliance on your own. If the problem persists after performing the
inspection, please contact an authorised service centre, a qualifi ed technician or the vendor from
whom you purchased the appliance.
Problem Possible cause Solution
The appliance is not
working.
The appliance is not turned on. Turn on the appliance.
The power cord is connected to a
power socket, or is not loosened.
Check the power cord.
A fuse is burned out or damaged. Check the fuse.
The power socket is damaged. Contact a qualifi ed electrician.
The appliance cools too
much.
The temperature is set too low. Change the temperature.
The appliance is not
cooling suff iciently.
The correct temperature is not set. Change the temperature.
The door was left open for a longer
period of time.
Only open the door for the necessary
time.
You have placed a large amount of
food inside.
Set a lower temperature.
The appliance is near a heat source.
Move the appliance or the heat
source – more information in a
preceding part of this user's manual.
The light does not light
up.
The light tube is destroyed. Change the light tube.
Large layer of frost
especially near the gasket
seals.
The gasket seals are not sealing
properly (probably after the
door opening direction has been
changed).
Carefully heat up the frost deposit
using a fan (set to cold air current).
At the same time use your hand to
shape the door gasket to remove
frost and to make sure that the
gasket is correctly seated.