Philco PLD 1271 - Příručka (Stránka 19)

EN - 17
04/2012 Copyright © 2011, Fast ČR, a. s.
SECTION 5: MAINTENANCE AND CLEANING
• Unplug your machine.
• Close the water tap.
WATER INLET FILTERS
On the tap part of your machine’s water inlet hose and at the ends of water inlet valves, there are fi lters to
prevent entrance of the dirt and foreign materials in the water to the machine. If the machine is unable to
receive suffi
cient water although your water tap is opened, these fi lters should be cleaned.
• Remove the water inlet hose.
• Remove the filters found on the water inlet valves by using a pincer and wash thoroughly with a brush.
• Clean the filters of the water inlet hoses located on the tap side by removing manually together with the seal.
• After you clean the filters, you can fit them the same way as you have removed.
Attention:
The water inlet valves may be blocked by a contaminated water supply or because of inadequate
necessary maintenance, or the valves may be damaged, which may cause a water to constantly
fl ow through. For these reasons such types of malfunctions are not covered by the warranty.
PUMP FILTER
The pump fi lter system elongates the life of your pump, which is used to drain the dirty water. It prevents lint to
enter the pump. Cleaning of your pump fi lter in every 2-3 months is recommended. To clean your pump fi lter:
• Open the cover on the bottom moulding.
• Before opening the filter cover, place a cup in front of the filter cover to prevent flow of the remaining
water in the machine.
• Loosen the filter cover by rotating it counter clockwise and drain the water.
• Remove the foreign materials from the filter.
• Check for the rotation of the pump manually.
• After you have cleaned the pump, fit the filter cover by rotating clockwise.