Philco PLD 1271 - Příručka (Stránka 25)

EN - 23
04/2012 Copyright © 2011, Fast ČR, a. s.
FAILURE PROBABLE CAUSE METHODS OF ELIMINATION
The washing result is not good.
Clothes exceeding the maximum
capacity has been fi lled in your
machine. Put the clothes in your machine
in a manner not to exceed its
maximum capacity.
Your water may be hard.
Use the amount of detergent
according to the declaration of the
detergent producer.
Distribution of the clothes in your
machine is not well-balanced.
Spread the clothes inside the
machine in an orderly and
well-balanced manner .
The water is drained from the
machine as soon as it is fi lled.
The end of the water drain hose
is in a position too low according
to the machine.
Place the water drain hose in an
appropriate height.(**)
No water is seen in the drum
during washing. No failure. The water is at the
lower part of the drum.
-
There are residues of detergent
on the clothes.
The pieces of some detergents
which do not dissolve in water
may stick to your clothes as white
stains.
By calibrating your machine for
“Rinsing” program,make an ad-
ditional rinsing or eliminate the
stains After drying with the help
of a brush.
There are gray stains on the
clothes. These stains may be caused by
oil,cream or ointment .
In the next washing operation,
use the maximum detergent
amount declared by the detergent
producer.
The spining process is not done
or starts with delay . No failure. The unbalanced load
control may works in that way.
The unbalanced load control
system will try to distribute your
clothes in a homogenous manner.
After your clothes are distributed,
passage to spining process will
be realized.In the next washing
process,place your clothes into
the machine in a well-balanced
manner.
(**) See the section concerning instalations your machine.