Philco PGG 64 - Příručka (Stránka 15)

EN - 13
03/2012 Copyright © 2012, Fast ČR, a. s.
When inspecting a fl exible hose, check whether:
•
it has any tears, cuts or signs of burning.
• the connecting clamps are causing cuts.
• the material is elastic, it must not be brittle.
• its lifetime has expired.
If you identify any of the above signs, do not repair the hose, replace it instead.
It is important to install pipes correctly. Incorrect installation may cause gas leaks.
CAUTION!
After completing the installation, check that every pipe joint seals perfectly by using a soap
solution.
NEVER USE A FLAME TO CHECK FOR GAS LEAKS!!!
Electrical wiring connection
Connect the appliance to a single-phase electrical power supply with a voltage of 230 V. Before connecting
the appliance, check that the voltage on the appliance's rating label corresponds to the voltage in your power
socket.
The connection must be carried out in accordance with valid laws and regulations.
Before connecting this appliance, check that:
•
the power supply is properly grounded according to valid codes.
• the main fuse and the domestic electrical wiring correspond to the given load (see rating label).
• the wall socket or bipolar switch used for the electrical connection are easily accessible even after the
appliance is built-in to the cabinet.
The appliance is supplied with a power cord equipped with a proper power plug suitable for the given load
marked on the rating label. The plug must be inserted into a properly grounded power socket.
If you will be connecting the appliance directly to the electricity grid it is necessary to install a bipolar switch
between the appliance and the grid with a minimum distance between contacts of 3 mm. This switch must
correspond to the required load in accordance with valid codes.
Do not use an adapter to connect the appliance to a mains power socket.