Philco PGG 64 - Příručka (Stránka 18)

EN - 16
03/2012 Copyright © 2012, Fast ČR, a. s.
Before installing the cooktop into the cut out, fi rst place a sealing adhesive tape on to the underside edge of
the cooktop. Check that no gaps remain in the seal through which liquids spilled in the vicinity of the cooktop
could enter into the bottom cabinet.
1. Remove the protective grill, cover and crown of the burner and turn the cooktop upside down. Take care
not to damage the spark plugs.
2. Place the sealing tape around the entire top perimeter. Check that the ends touch but do not overlap.
3. Place the cooktop into the cut out and centre it.
4. Secure the cooktop in place using suitable clamps supplied together with the jet pack. Do not use glues,
silicone or other similar substances to attach the cooktop.
Built-in options
a) Kitchen cabinet with doors
If you will be installing the cooktop into a kitchen cabinet with doors and a top cover, it is necessary to perform
certain modifi cations in the design of the cabinet so that the hot underside of the cooktop does not come into
direct contact with the cabinet. The minimum recommended distance between the underside of the cooktop
and the top part is 10 cm. The panel under the cooktop must be easily removable for easy access in the event
of a repair event.
If you will be performing an installation into a kitchen cabinet without a top cover it is necessary to maintain
a minimum recommended distance from inserted items and foods.
b) Kitchen cabinet with an oven
If you will be installing the cooktop into a kitchen cabinet with an oven it is necessary to maintain minimum
distances noted above and it is necessary to ensure that the cooktop has a suffi
cient supply of air.
Install according to the illustrations below to avoid it from overheating.
For safety reasons the electrical wiring connection of the cooktop and the oven must be separate so that it is
possible to easily remove the oven from the cabinet if necessary.