Philco PGG 64 - Příručka (Stránka 16)

EN - 14
03/2012 Copyright © 2012, Fast ČR, a. s.
The power cord must be located in such a way that at no point can its temperature exceed 90 °C.
The brown phase lead (connected to the terminal box to the contact marked with the letter "L") must always
be connected to the phase in the grid.
If you will not be using the appliance for a longer period of time, before cleaning, maintenance, moving, etc.,
remove the power plug from the power socket to prevent overheating or a fi re hazard.
NOTE:
The manufacturer takes no responsibility for damage or injury caused by incorrect installation,
unprofessional, incorrect or inappropriate use of the appliance.
If the power cord is damaged, do not use the appliance, disconnect it from the power socket and have the
power cord replaced at an authorised service centre or by a qualifi ed person. The replaced power cord
must correspond to the parameters designated by the manufacturer (T90°C).
The appliance must be installed according to the instructions contained in this user's manual and
according to the standards valid in the country of its use.
Installing the cooktop
The cooktop can be installed into a built-in kitchen cabinet which is resistant to temperatures up to 90 °C.
The dimensions of the cooktops are provided further on in the manual.
Prior to placing the cooktop into the kitchen cabinet, it is necessary to adhere to the following dimensions:
1) Minimum distance from the edge of the cut out to the rear wall must be at least 100 mm.
2) Minimum distance from the edge of the cut out to the side wall, walls of furniture, etc. must be at least
100 mm.
3) Minimum distance from the edge of the cut out to a suspended cabinet or a range hood must be at least
650 mm.