2N NetStar Mobility Extension configuration manual Uživatelská příručka
Stránka 34
34
1.
2.
3.
4.
5.
Configuration of routing of incoming calls
with Mobility Extension
What is necessary:
external station
routing "From port"
router according to port
DISA direct inward dialing
permitted transmission for putting a call on hold
Routing of incoming calls of external stations is associated with recognition of these
calls immediately after the call has arrived at one of the ports of the Ateus Netstar
. Recognition is based on compliance of CLIP (caller identification) with its subtype.
PBX
Further routing is then governed by the settings at the recognized external station
("Routing" tab in the station properties). This tab is shown on
. The tab called
Figure 5
"From port" is related to the routing of the incoming call. The figure shows settings of
routing to the router according to the port. An example of a possible configuration of
such router is shown on
. For easier understanding the annex (
)
Figure 6
Annex 1
shows a flow chart of processing of an incoming call of an external station.
Figure 5: View of the "Routing" tab with a router included according to port
When looking at the router (
), it may appear as an unnecessary element, but
Figure 6
in the event of direct inclusion of DISA direct inward dialing the caller would not be
able to use certain services (e.g., putting a conference call together or back calling).
The same picture also shows configuration suitable for direct inward dialing when the
caller is routed directly to another router, where the direct dialing is made according to
the number called.