LG F1091QD - Příručka (Stránka 276)

nstallation
Installation place requirement
Level floor:
Allowable slope under entire washer Is 1°
Power outlet:
Must be within 1.5 meters of either side of location of
washer. Do not overload the outlet with more than one
appliance.
Additional Clearance:
For wall, door and floor modeling Is required.
(10cm : rear /2cm:rlght & left side)
Do not place or store laundry products on top of washer at
any times.
They can damage the finish or controls.
■ Positioning
Install the washer on a flat hard floor.
Make sure that air circulation around the washer is not impeded by carpets, rug etc.
• Never try to correct any unevenness in the floor with pieces of wood, cardboard or similar
materials under the washer.
• If it is impossible to avoid positioning the washer next to a gas cooker or coal burning stove, an
insulation(85x60cm) covered with aluminum foil on the side facing the cooker or stove, must be
inserted between the two appliance.
• The washer must not be installed in rooms where the temperature can drop below 0°C.
• Please ensure that when the washer is installed, it is easily accessible for the engineer in the
event of a breakdown.
• Adjust all four feet using the transit bolt spanner provided ensuring the appliance is stable, and a
clearance of approximately 20mm is left between the top of the washer and the underside of the
work-top.