Fenix CH2000B TURBO - Příručka (Stránka 10)

10
WALL MOUNTING
The heater is supplied with 4 off each fixing brackets, screws and plastic wall plugs to enable it to be
mounted onto a wall if required.
If it is decided to mount the heater on the wall, the feet should not be fitted. The position must be chosen
carefully. It must not be in front of or below a power socket. It must not be below a shelf, curtains or any
other obstruction. Also refer to the safety instructions overleaf.
Having decided on the location of the heater it is necessary to drill 2 fixing holes 8 mm diameter by 43
mm deep at 486 mm centers on a horizontal line at a minimum height of 400 mm from the floor. Allow-
ance must be made for any floor coverings, carpet etc and if any skirting boards are present, the fixing
holes must be a minimum of 400 mm above the top edge of the skirting board. Using the plastic plugs and
fixing screws provided, attach 2 of the fixing brackets to the wall. The other pair of fixing brackets must
be attached to the base of the heater using the feet retaining screws so that the brackets project out at the
rear of the heater and space the bottom edge away from the wall.
If required, these brackets may also be secured to the wall using the remaining fixing screws and plastic
wall plugs. If this option is chosen it is suggested that the heater is hung on the upper brackets and the hole
positions for the lower brackets is then marked on the wall, prior to drilling the holes for attachment pur-
poses.
CLEANING THE HEATER
Always un-plug the heater from the wall socket and allow it to cool down before cleaning.
Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth. Do not use any
detergents or abrasives and do not allow any water to enter the heater.
STORING THE HEATER
When the heater is not used for long period, it should be protected from dust and stored in a clean dry
place.
NOTE
If the supply cord is damaged, it must be replaced but the manufacturer or its service agent or a similarly
qualified person in order to avoid a hazard.
The product is for household use only The heater must not be located immediately below a socket-outlet.
Don’t use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
WARRANTY CONDITIONS
The supplier provides a 24-month warranty for this product from the date of sale. The warranty does not
cover faults caused by transportation, careless manipulation or unqualified installation. The warranty also
does not cover everyday wear and tear on the product. Any alterations made to the product are considered
a breach of the warranty conditions.
Complete warranty conditions can be found on the web pages - www.fenixgroup.cz.