Philco PT 569 Maestro - Příručka (Stránka 7)

EN - 5
02/2015 Copyright © 2015, Fast ČR, a. s.
• Do not place explosive or fl ammable material in your fridge for
your safety. Place drinks with higher alcohol amount vertically
and by closing their necks tightly in the fridge department.
• When taking ice made in the freezer department, do not touch it,
ice may cause ice burns and/or cuts.
• Do not touch frozen goods with wet hands! Do not eat ice-cream
and ice cubes immediately after you have taken them out of the
freezer department!
• Do not re-freeze frozen goods after they have melted. This may
cause health issues like food poisoning.
• Do not cover the body or top of fridge with lace. This aff ects the
performance of your fridge.
• Fix the accessories in the fridge during transportation to prevent
damage to accessories.
Installing and operating your fridge
Before starting to use your fridge, you should pay attention to the following points:
•
Operating voltage for your fridge is 220-240 V at 50Hz.
• We do not take the responsibility of the damages that occur due to ungrounded usage.
• Place your fridge in a place that it would not be exposed to direct sunlight.
• Your appliance should be at least 50 cm away from stoves, Gas ovens and heater cores, and should be at
least 5 cm away from electrical ovens.
• Your fridge should never be used outdoors or left under the rain.
• When your fridge is placed next to a deep freezer, there should be at least 2 cm between them to prevent
humidity on the outer surface.
• Do not place anything on your fridge, and install your fridge in a suitable place so that at least 15 cm is
available on the upper side.
• The adjustable front legs should be adjusted to make sure your appliance is level and stable. You can adjust
the legs by turning them clockwise (or in the opposite direction). This should be done before placing food
in the fridge.
• Before using your fridge, wipe all parts back with warm water added with a tea spoonful of sodium
bicarbonate, and then rinse with clean water and dry. Place all parts after cleaning.
• Install the plastic distance guide (the part with black vanes at the rear) by turning it 90° as shown in the
fi gure to prevent the condenser from touching the wall.
• Refrigerator should be placed against a wall with a free distance not exceeding 75 mm.