Philco PDA 15103 X - Příručka (Stránka 16)

EN - 14
06/2013 Copyright © 2013, Fast ČR, a. s.
1. To enter the menu for changing the water hardness, press and hold down the additional function selection
button and the delayed start button at the same time for about 3 seconds. At the same time the message
"Keep Pressing ..X" (Keep pressing X) will appear on the display, indicating how long you should press the
buttons. As soon as 0 appears on the display, the heading on the display will change to "Settings Menu"
(Settings menu).
2. Now use the up/down buttons to select "2. Water Hardness: X" (2. Water hardness: X). In this case, one
of the following values will appear under "X": L01, L02, L03, L04, L05, L06.
3. Now press the confi rm button and the "X" value will start to fl ash. Use the up/down arrows to select the
appropriate value.
4. Press the confi rm button to save the new settings. The message on the display will change to "Stored"
(Saved).
5. After saving, the display will automatically return to the water hardness settings menu.
6. To exit the water hardness menu, press and hold the additional function selection button and the delayed
start button at the same time for about 3 seconds, or use the up/down buttons to select option "7. Exit Menu"
(7. Exit from menu) and confi rm with the confi rm button.
NOTE:
Your water supplier will provide you with information about the hardness of your water.
CAUTION!
If your dishwasher does not have a water softening system, you can skip this chapter.
Adding salt into the salt container
Always use salt designed for dishwashers.
The salt compartment is located under the lower rack and you should refi ll it in the following manner.
NOTE
 Use only salt specifi cally designed for use in dishwashers! Any other kind of salt, which is not
specifi cally designed for use in dishwashers, particularly table salt, would damage the softener
system in the dishwasher. Damage caused by the use of inappropriate salt is not covered by
the manufacturer's guarantee and the manufacturer takes no responsibility for any damages
caused.
 Add the salt before starting one of the full washing cycle programs. This will prevent salt
crystals or salt water from lying at the bottom of the dishwasher, where this could lead to
corrosion.
salt
a) Slide out the lower rack and then unscrew the lid of the salt compartment.
b) Before the fi rst wash, pour water into the salt compartment.