Philco PDA 15103 X - Příručka (Stránka 36)

EN - 34
06/2013 Copyright © 2013, Fast ČR, a. s.
Cleaning the fi lters
To clean the coarse and fi ne fi lters use a brush. Reassemble the individual parts of the fi lter as shown on pictures
1 – 5 (pictures above). Reinsert them back into the dishwasher in their place and press them downwards.
WARNING!
Do not knock on the fi lters when cleaning them. Otherwise the fi lters could bend, which would
lower the effi
ciency of the dishwasher.
Never use the dishwasher without a fi lter. An incorrectly seated fi lter may lower the effi ciency
of the dishwasher and cause damage to dishes.
Dishwasher care
You can clean the control panel using a light damp wiping cloth. Thoroughly dry the area after cleaning.
Clean the exterior parts of the dishwasher using a quality polish.
Never use any sharp items, steel wool or coarse, sandy cleaning products to clean any part of the dishwasher.
Cleaning the door
To clean the door edges use a soft, warm, damp wiping cloth. To prevent water leaking into the door lock or its
electronic parts, do not use any cleaning agents in sprays.
WARNING!
 Never use cleaning agents in sprays to clean the dishwasher door because
this could damage the door lock and electrical parts.
 Do not use sandy cleaning agents or certain types of kitchen paper towels, because
they could scratch or leave marks on the stainless steel parts of the dishwasher.
Protection against frost
In winter take steps against the dishwasher freezing. After every wash do the following:
 Disconnect the dishwasher from the power source.
 Close the water inlet and disconnect the supply hose from the water valve.
 Drain water from the water supply hose and the water valve. (Drain the water into a container.)
 Reconnect the water supply hose to the water valve.
 Take out the fi lter on the bottom of the dishwasher and using a sponge suck up the water from the waste
tank.
NOTE
If your dishwasher is not working because it has frozen, contact an authorised service technician.