Philco PDA 15103 X - Příručka (Stránka 38)

EN - 36
06/2013 Copyright © 2013, Fast ČR, a. s.
PART 10: PREVENTION OF MINOR MALFUNCTIONS
Technical
problems
Problem Possible causes What to do
The dish-
washer will
not start.
A burned fuse or the
circuit breaker is off .
Replace the fuse or turn on the circuit breaker. Disconnect any other
appliances sharing the same circuit with the dishwasher.
Power source is not
turned on.
Check that the dishwasher is turned on and the door is shut properly.
Check that the power plug is correctly connected to the power socket.
Water pressure is low.
Check that the water supply is correctly connected and whether it
is open.
The dishwasher door
is not closed properly.
Check that the door is closed properly
and secured with the latch.
Water is
not drain-
ing out of
the dish-
washer.
There is a knot on the
hose.
Check the drain hose.
The fi lter is clogged.
Check the coarse fi lter
(see section "Cleaning the fi lters").
The kitchen sink
is clogged.
Check the kitchen sink and ensure that it drains well. If the problem
is an incorrectly draining sink, fi rst call a plumber and only then the
service technician.
General
problems
There are
suds in the
dishwash-
er.
An incorrect dishwashing
detergent was used.
Use only special detergents for dishwashers to prevent the
formation of suds. If this occurs, open the dishwasher and allow
the suds to evaporate. Pour 0.4 l of cold water into the dishwasher.
Close the dishwasher to the latch and then start the rinse cycle to
drain the water.
Repeat if necessary.
Rinse aid has spilled out. Always immediately clean the rinsing aid.
There are
stains
inside the
dishwasher.
You used a dishwashing
detergent with dyes.
Use a dishwashing detergent not containing dyes.
There is a
white
deposit
inside the
dishwasher
The white fi lm is caused
by the minerals in hard
water.
Clean out the inside of the dishwasher using a damp sponge with
detergent. Use rubber gloves.
To prevent the risk of the formation of suds
never use any other detergents than those designed for use with
dishwashers.
There are
rust stains
on the
cutlery.
The aff ected items are not
resistant to corrosion.
After refi lling the salt you
did not start any program.
Salt particles got into the
washing cycle.
After adding salt always run a quick wash without dishes and
without the Turbo function activated (if available).
Loose water softener lid Check the lid. Check that it is pulled tight.
Noise
A banging
sound is
coming out
of the dish-
washer.
The spraying arm is hitting
some dishes located in
a rack.
Interrupt the program and rearrange the dishes, so that they no
longer interfere.
A rustling
sound is
coming out
of the dish-
washer.
Dishes are placed loosely
in the dishwasher.
Interrupt the program and rearrange the dishes.
A knocking
sound is
coming
out of the
hoses.
This may be caused by
the installation or the
diameter of the hoses.
This has no aff ect on the operation of the dishwasher. If in doubt
contact an authorised service plumber.