Philco PDA 15103 X - Příručka (Stránka 40)

EN - 38
06/2013 Copyright © 2013, Fast ČR, a. s.
Error codes
Codes Meaning Possible causes
F5
Insuffi cient
water supply.
Check that the water inlet is fully open and that your water supply has
not been interrupted.
Shut off the water inlet. Disconnect the supply hose and clean out the fi lters.
Turn the dishwasher off and then on again. If the problem persists contact
an authorised service centre.
F3 Continuous water supply. Close the water inlet and contact an authorised service centre.
F2
Insuffi cient
draining of water
The drain hose is clogged.
The fi lters are clogged.
Turn the dishwasher off and then on again. If the problem persists contact
an authorised service centre.
F8 Heat sensor error Contact an authorised service centre.
F1 Dishwasher overfl owed.
Turn off the dishwasher, close the water inlet and contact an authorised
service centre.
FE
Malfunction of the heat
sensor
Contact an authorised service centre.
F7
Overheating of the
dishwasher
(temperature is too high.)
Contact an authorised service centre.
F9 Fault ???? Contact an authorised service centre.
F6
Malfunction of the heat
sensor
Contact an authorised service centre.
WARNING!
 In the event that the dishwasher becomes fl ooded, close the water supply before calling the
service technician.
 If as a result of fl ooding or a water leak there is water in the bottom container, pour it out
before turning on the dishwasher again.
Warning messages
Open the water inlet.
If this warning message appears:
- check that the water supply has not been interrupted;
- check that the main hydrant is in order;
- contact an authorised service centre if both the above-mentioned solutions are in order.
Whenever the following messages appear, contact an authorised service centre.