Philco PDA 15103 X - Příručka (Stránka 29)

EN - 27
06/2013 Copyright © 2013, Fast ČR, a. s.
PART 8: OPERATING THE DISHWASHER
Turning on the appliance / starting a washing program
1. Pull out the lower and upper rack, load it with dishes and then slide back in.
• We recommend that you fi rst load the lower rack and only then the upper rack.
2. Fill the compartment with dishwashing detergent (see section "Dosage of the dishwashing detergent").
3. Connect the power plug to the power socket. Power source is 220 - 240 V ~ 50 Hz, power socket specifi cation
12 A, 250 V ~. Check that the water inlet is fully open.
4. Press the main power switch.
5. Use the up/down arrows to select a washing program. Select a program based on the degree to which
the dishes are soiled – see the program table. The washing time of the program will be shown on the
remaining time / delayed start indicator.
6. If necessary, select an additional function.
7. To start the program press the Start/Pause button. The display will show "Program Activated" (Program
activated) and the selected program will start.
Once a program is started, the name of the selected program will appear on the information panel, the
remaining time of the washing cycle will appear on the remaining time / delayed start indicator. The number
of the washing program will appear on the program number indicator.
Super 50'
NOTE:
Do not open the dishwasher door during a washing cycle; if you do need to open the dishwasher door,
press the Start/Pause button. The message "Program Paused" (Program paused) will appear on the
display. You can open the door when this message appears. Nevertheless, be very careful when opening
the door as steam, which may form after the door is opened, may be very hot and may easily cause
scalding or other injuries.
Restart a paused program by closing the door and pressing the Start/Pause button. The message
"Program Activated" (Program activated) will appear on the display after the button is pressed and the
selected program will continue in the washing cycle.