LG F1089QD - Příručka (Stránka 286)

nstallation
Normal Tap without thread & screw type inlet hose
1. Unscrew the fixing screw to
attach the tap.
Upper
ОопгесФэг
Fixing
Ri±ber
'Vfi ***''!*'' packing
" fete#
2. Push the connector up till the 3. Push the water supply hose
rubber packing is in tight
contact with the tap. Then
tighten the 4 screws.
Upper
Cgnnectpr'
Rubber paclting I'V,' i'. h' ,.4
^
•••••. \ I . ^
vertically upwards so that the
rubber packing within In the
hose can adhere completely to
the tap and then tighten it by
screwing It to the right.
■ Upper
uonncctor
Vifater euppV ^
ryise ' fv Ч
Normal Tap without thread & one touch type inlet hose
1. UntIghten the upper connector
screw.
2. Push the upper connector up 3.
till the rubber packing Is In
tight contact with the tap. Then
tighten the 4 screws.
=ljbber3a;Un'3
• In case the diameter of the tap Is
large remove the guide plate.
Guide elete
Connect the water supply
hose to the middle connector,
pushing the plate down.
r.iiddie
cuiirieuty
■ Turn the middle connector rot
to have water leaked.
■ Make sure that the rubber seal
is Inside the hose connector.
• To separate the water supply
hose from the middle
connector shut off the tap.
Then pull the inlet hose down,
pushing the plate down.
• Your machine comes with
only ould water coniiecLiun.
■ Make sure that there are no
kinks in the hose and that it
is not crushed.