LG F1089QD - Příručka (Stránka 307)

roubleshooting guide
Symptom
Possible Cause Solution
■Water supply is not adequate in area.
• Water supply taps are not completely open.
■Water inlet hose(s) are kinked.
■ The filter of the inlet hose(s) are clogged. Check another tap in the house.
Fully open tap.
Straighten hose(s).
Check the filter of the inlet hose.
■Drain hose is kinked or clogged.
• The drain filter is clogged. Clean and straighten the drain hose.
Clean the drain filler.
• Load is too small.
■ Load is out of balance.
• The appliance has an imbalance detection and
correction system. If individiial heavy articles
are loaded {ex. bath mat, bath robe, etc.) this
system may stop spinning or even interrupt
the spin cycle altogether.
• If the laundry is still too wet at the end of the
cycle, add smaller articles of laundry to
balance the load and repeat the spin cycle.
Add 1 or 2 similar items to help
balance the load.
Rearrange load to allow proper
spinning
' Is the door opened?
Close the door.
* If
‘'dE
" is not released, call for
service.
Unplug the power plug and call for
■ Water overfills due to the faulty water valve.
• Water level sensor has maltunctioned.
Close the water tap.
Unplug the power plug.
Call for service.
■ Over load in motor.
■Over load in motor.
■ The washer experienced a power failure. Restart the cycle.
29