LG F1089QD - Příručka (Stránka 297)

ow to use washer
Child LockicS:)
Tub Clean( *)
If you choose to lock the buttons on the control
assembly to prevent tampering this function may
be selected.
• Child Lock can be set by pressing the Medic
Rinse( E?) button and Pre WashCaf) button
simultaneously. (About three seconds)
•To deactivate Child Lock system, press Medic
Rinse( e?) and Pre Wash(i^) buttons
simultaneously again. (About three seconds)
■To change to the desired program, whilst in
child lock mode.
1. Press both Medic Rinse( S') and
Pre Wash(5a?) together once again.
(About three seconds)
2. Press the Start/Pause button.
3. Select the desired program and press the
Start/Pause button again. •
Change the
desired O
program
%
• The child lock can be set at any time and it can
be deactivated only by using child lock cancel
process. Turning the power off and operational
errors will not affect child lock.
Tub Clean course can be set by pressing and
holding lntensive( ' 2 f) and Crease Care{.i3)
button simultaneously.
When Tub Clean course is set. display "
and all buttons are inoperable.
TUB CLEAN is special cycle to dean the inside
of the washer. This cycle uses higher water level
with higher spin speed. Perform this cycle
regularly.
How to use the Tub Clean cycle:
1. Remove any clothing or items from the washer
and dose the door.
2. Open the dispenser drawer and add Anti
limescale (Calgon) to the Main wash
compartment
NOTE: Do not add any detergent to the detergent
compartments. Excessive suds may
generate and leak from the washer.
3. Close the dispenser drawer slowly.
4. Power On and then press and hold
Intensive! 13 ) and Crease Care{j^ ) button
for3 seconds, then " Is displayed in LED.
5. Press Ltie Slarl/Pause buLlon to sLarl.
6. After the cycle is complete, leave the door
open to dry around the washer door opening,
flexible gasket and doer glass.
A CAUTION: If there is a small child, be
carelul not to leave the door
open for too long.
19