Fenix GR panel - Příručka (Stránka 8)

8
Mounting instructions
Installation, electric connection and first commissioning can by performed by
worker with adequate qualification. Panels are intended for installation on a
wall. The manufacturer must be consulted before any other form of installa-
tion is attempted.
Distances
Distance of the lower edge of the appliance from the floor must not be
smaller than 50 mm, 150 mm recommended. Distance sidelong, e.g. to
furniture, must be minimum 100 mm (see picture 2). In Bathrooms, the
panel must be installed in conformity with IEC 364-7-701:1984 and may be
located in compliance with the picture 1 in the zones 2 and 3. The panel is
gadget of the class II and is protected against spraying water, protection IP
44. The panel must not be located directly under mains outlet. Electrical
installation is to be equipped with double pole switch, by which the distance
of open contacts is equal to min. 3 mm.
Mounting
The panel is wrapped separately in a cardboard cover and for mounting on
the wall serves mounting consoles. The panel can be installed on the wall
lengthwise or widthwise; mounting the panel on the ceiling is forbidden
(pic. 4). Drill the holes for the mounting brackets according to pic. 5
(lengthwise panel installation) or pic. 6 (widthwise installation). Dimensions
A are hole spacing's and dimensions B, C and D are minimum dimensions of
holes from surrounding objects.
Please, fix consoles on the wall by means of spins in wall plugs (they are not
part of the products), these are to be chosen with regard to kind of wall
material and higher weight of the panel (for drywall thickness. min. 12.5 mm
for example MOLLY / Rigips, Hartmut / Kanuf).
Please, hang the panel on the consoles always on upper two screws
(according to the hang) and tighten fast by means of prepared nuts with
washers. Mounting nuts are screwed on two screws of the panel, prepared
to hang them horizontally.
Besides mounting consoles, also adjusting supports are added to the panel,
by which after screwing on the lower screws of the panel, the distance of
the panel from the wall is defined and the mounting bracket cover (pic. 3).
On the picture 3, the side view on the panel after hang on the wall is dis-
played.
Pic.2
Pic.1
Dimensions are stated in mm
Pic.4
1. Glass panel
2. Consoles
3. Adjusting supports
4. Wall
5. Wall plugs with spins
6. Terminal box
7. Bracket cover
Pic.3