Fenix ECOFLEX G - Příručka (Stránka 9)

9
Notice
•
When fixing the convector to the supporting structure, lift the convector until it slips on all clips.
•
Between the iron grill and the glass plates, protective bands from expanded polystyrene are inserted against damage during
transport and mounting. Before the first start of the convector, remove these bands.
•
During the first start of the convector, it comes to burning of the heater, which is accompanied by release of fumes with
slight bad smell. This effect is a short- time one and by other use does not come again.
•
Because it is a fragile material, it is necessary to take care during transfer, handling and mounting.
Economic operation
If you ventilate the room in the long term, switch- off the convectors. If you do not use the room, e. g. the guest- room or the
whole house over a longer period, (holiday) set the roller of the thermostat in the position *. The room temperature will be
automatically kept on the value of ca. 7 °C
Important safety instructions - WARNING
•
In no case do cover convector. The notice „DO NOT COVER" warns that any material, by which the panel is covered, can
cause the fire. It is not allowed to place any furniture or to hang curtains before convector (see picture 7) and free air
circulation must be ensured. Regularly, at least before beginning of heating period, you should remove dust from the input
and output grill!
•
Convectors can be mounted on grounds of the flammability class C1, C2.
•
Any intervention in the convector can be performed only by qualified person. Before begin of such a work, the convector
must be disconnected (switched- off) from the current source. If the convector is controlled by means of the pilot conductor,
make sure before begin of the work that the feeder cable and the pilot conductor are disconnected.
WARNING : If the glass is damaged, the heating device cannot be used.
Technical data
Conditions of guarantee
The supplier provides for the products 24- month- guarantee since sale- by date. The guarantee does not refer to defects caused
by transport, careless handling and unauthorized mounting. The guarantee does not also refer to unauthorized intervention in
panel and to ordinary wear and tear of the product. Any intervention in the product is regarded as breach of conditions of
guarantee.
Certificate of sale:................................................................................................................................................
Sell- by date:........................................................................Serial number..........................................................
Seller:.....................................................................................................................................................................