Philco POB 321 - Příručka (Stránka 21)

EN - 19
04/2012 Copyright © 2012, Fast ČR, a. s.
PART 5: CLEANING AND MAINTENANCE
Before cleaning or standard maintenance make sure that the function selection dial, the temperature dial and
the timer (if available) are in the zero position, the oven is turned off and the power cord is pulled out of the
power socket, or where applicable the circuit breaker to which the appliance is connected is disengaged.
Do not use cleaning agents which could damage the enamel or varnish surface of the oven.
Only use cleaning agents intended for the cleaning and maintenance of your oven.
For cleaning do not use coarse cleaning agents, steel wool or sponges with steel wool. Do not use petrol,
benzene, solvents or any other similar substances. This could damage the oven, particularly the enamel or
varnish surface, and negatively aff ect the performance and operation of the oven.
Do not use steam cleaners for the cleaning or maintenance of the oven.
Cleaning the inside areas of the oven
Check that the oven is turned off .
Cleaning will be easier if the oven is a little warm.
Using a clean soft wiping cloth lightly dipped in warm water with a small amount of dishwashing detergent
wipe the inside area of the oven. Then wipe using a wiping cloth dipped in clean water and wipe dry.
To increase the lifetime of the oven, we recommend that it is cleaned regularly.
Changing a light bulb
The light should be replaced by an authorised technician or another qualifi ed person.
Check that the oven is turned off and cold.
Remove the front light cover, screw out the light bulb and replace it with a light bulb of the same type. It must
be resistant against temperatures up to 300°C, type E14, max. 25 W.
Return the cover to its place and check that the light works.