C) installation — system with direct heating, C) montáž — přímotopný systém – Fenix PSV Uživatelská příručka

Stránka 6

Advertising
background image

6

c) Installation — system with direct heating

INSTALLATION UNDER FLOOR TILES IN SEALING GEMENT

•

Please read first the General Terms and Conditions on
page 1.

•

To allow for expansion around the periphery of the
room between the baseboards and the floor tiles,
use an expansion profile or fill the spaces with
silicone sealing cement.

PROCEDURE:

•

Create “pockets” in the base material where you will place connec-
tions for the heating components.

•

Clean the base area, remove any sharp objects and penetrate it
using a suitable penetrating solution.

•

Lay and affix the cable onto the surface so that it cannot move
when you apply the sealing cement.

•

Measure the heating circuit resistance and the insulation resis-
tance or the leakage current resistance and record the values in
the certificate of warranty.

•

Draw the scheme of the heating cable layout in the certificate of
warranty.

•

Use flexible adhesive sealing cement and a notched spreader to
smooth the floor surface (be careful not to damage the cable by
the sharp edge of the notched spreader).

•

Before laying the floor tiles, measure the heating circuit again and
record both values in the certificate of warranty.

•

Lay the floor tiles on the surface.

c) Montáž — přímotopný systém

INSTALACE POD DLAŽBU DO LEPÍCÍHO TMELU

•

Nejprve si přečtěte Všeobecné podmínky na
straně 1.

•

Pro obvodovou dilataci mezi soklem a dlažbou
použit dilatační profil, nebo spáry vyplnit silikono-
vým tmelem.

POSTUP

•

V podkladovém materiálu vytvořte „kapsy“ pro uložení spojek
topných částí.

•

Podkladovou plochu očistěte a zbavte ostrých předmětů, a napene-
trujte vhodným penetračním přípravkem.

•

Položený kabel zafixujte tak, aby se při nanášení tmelu nemohl
posunout.

•

Proveďte proměření odporu topného okruhu a izolačního odporu,
nebo unikajícího proudu a hodnotu zapište do Záručního listu.

•

Do Záručního listu zakreslete rozložení topného kabelu.

•

Flexibilním lepícím tmelem za pomocí hladké stěrky srovnejte
podlahovou plochu (dbejte, aby jste ostrou hranou stěrky nepoško-
dili kabel).

•

Před položením dlažby opět proveďte měření topného okruhu
a obě naměřené hodnoty zaznamenejte do Záručního listu

•

Položte dlažbu

Direct heating system — new constructions / Přímotopný systém — novostavby

1) Floor tiles /

Dlažba

2) Flexible adhesive sealing cement /

Flexibilní lepící tmel

3) Installation pipe with a floor probe

/ Instalační trubka

s podlahovou sondou

4) ECOFLOOR heating cable /

Topný kabel ECOFLOOR

5) Spread layer

/ Betonová vrstva

6) Reinforcing steel grid (KARI) /

Armovací ocelová sí (KARI)

7) Thermal insulation min. 80–100 mm /

Tepelná izolace min. 80 -

100mm

Advertising
Tato příručka se vztahuje na následující produkty: