Fenix Ecoflex PREMIER - Příručka (Stránka 10)

2. INSTALLATION RECOMMANDATIONS
This appliance must be installed in a way that it enables the heater to
brew a maximum air volume.
The appliance must be connected in a fixed horizontal position and in
compliance with legal regulations.
In Bathrooms, the panel must be installed in conformity with IEC 364- 7-
701:1984 and may be located in compliance with the picture 1 in the
zones 2 and 3. The panel is gadget of the class II and is protected
against spraying water, protection IP 24. The panel must not be located
directly under mains outlet. Electrical installation is to be equipped with
double pole switch, by which the distance of open contacts is equal to
min. 3 mm
IMPORTANT: « DO NOT COVER »
To avoid overheating, do not cover the heater in any circumstances.
The picture sticker « DO NOT COVER » reminds you of this risk.
It is strictly forbidden to cover or block the shades or air outlets
in order to avoid incidents or deterioration of the device. Please
avoid installation close to air outlets (chimneys, ventilation),
behind curtains or doors.
Please respect the minimum installation distances to the floor,
walls, furniture, etc ... (Picture B)
3. INSTALLATION AND WALL MOUNTING
Remove the bracket of the appliance using a screwdriver (Item 1). Attach the bracket to the wall using 4 screws (Ř 5, 5
mm max.) ensuring the right direction and at the right height (Fig. C).
Typ 1000W 1500W 2000W
Axle base [mm] 248 405 525
H [mm] 257 257 257
B [mm] 145 275 270
C [mm] 270 270 270