Fenix Ecoflex PREMIER - Příručka (Stránka 14)

6. MAINTENANCE
To maintain the performance of the heater, it is necessary to regularly remove dust inside the device by vacuuming the front
grid.
To remove outside dust, use a soft cloth. To remove a stain, moisten the cloth. Never use abrasives that can damage the
various coatings.
NEVER USE ABRASIVE OR ACETONE WHICH COULD DAMAGE THE EPOXY COATING!
SUGGESTIONS:
Children should be monitored in order to avoid them to play with the heater.
Do not insert anything into the device.
When switched on for the first time, a smelling can be noticed, this phenomenon disappears after a few minutes of operation.
If your device is connected to a load- shedding network: When load shedding is set as a priority, it is possible that the
heater does not work, in case of momentary over- consumption (washing machine + oven + iron). This is normal. Upon resto-
ration of normal consumption, the unit will re- heat.
This heater is intended to be connected to a mains supply of 230V 50Hz. This device is not intended to be used by per-
sons (including children) with physical, sensory or mental disability, or persons lacking experience or knowledge, unless they
are supervised or have been instructed by a person responsible for their safety.
All interventions on our devices must be carried out by a qualified and licensed professional.
7. PROBLEMS? SOME SUGGESTIONS
The appliance is not heating:
Ensure that the power installation is connected properly; on the heater itself as well as on the main board and that
the load shedding device (if you have one) does not cut power to the appliance.
The heater does not follow the programming instructions:
Make sure that you use the programming unit as intended (see its manual).
The appliance is heating permanently:
Verify that the device is not located in a current of air or the temperature setting has not been changed.
In case of a thermostat problem, cut the power (fuse, circuit breaker ... ..) for about 5 minutes and restart the
device.
If the problem occurs frequently, check with your energy supplier.
In all other cases contact a qualified person.
At the first use, a light smell related to the normal evacuation process during the manufacturing may occur.