Fenix Ecoflex PREMIER - Příručka (Stránka 13)

If you press any button on the keyboard, the display announces, by the symbol "FF", the
impossibility to proceed for any orders.
To remove the keypad lock, operate as above.
« PROG » MODE:
This mode permits the automatic operation through a programming unit.
To do this: Press the MODE button until the LED function light “PROG” is on.
PARTICULARITES:
Please note that when Economy, Comfort or Anti- Frost MODE is chosen by the user, priority is given to the Anti- Frost and
STOP orders sent by a programming unit. The function light "PROG” flashes orders are received by the appliance.
MODE
chosen by user
MODE by programmer
Anti- Frost Signal STOP Signal
19
ES
HG
DISPLAYS SETTINGS (THERMOSTAT / THERMOMETER)
Exceptionally, it may occur that there is a gap between the displayed temperature and your thermometer. In this case, it is
possible to harmonize the two settings.
This setting can be achieved only if your appliance is set between 17 and 23 °C.
All doors and windows must be closed.
Wait for the stabilization of the temperature in the room (at least 6 hours) and avoid as much as possible whereabouts in the room.
The temperature control should be placed in the middle of the room to 1.20m from the ground. Do not place it on any furniture.
Set the "Comfort" temperature with MODE button, e.g. 19
Push for 6 seconds MODE, this will open two possibilities:
1. Display is flashing 19, a modification is possible:
• Correct with the + and - buttons
• Confirm with MODE
2. FF is displayed, a modification is impossible (if temperature delta is more than
3°C or the comfort temperature s etting is not within 17°C- 23°C):
Note: If no action on + or - for 15 seconds, the display returns to its initial
position (19).