Philco PC 455 Adora - Příručka (Stránka 24)

EN- 22
02/2015 Copyright © 2015, Fast ČR, a. s.
SECTION 7: BEFORE CALLING SERVICE
Check Warnings
Your fridge warns you if the temperatures for fridge and freezer departments are in improper
levels or when a problem occurs in the appliance. Warning codes will be displayed on Cooler and
Freezer Indicators.
ERROR
CODE
MEANING REASON DO…
SR Failure warning Indicated when one or more
parts of the fridge fail or in case
of a problem in cooling system.
Contact the nearest authorized technical
service as soon as possible.
LV Low voltage It switches to standby status
when voltage supply of fridge
lowers below 170 Volt.
This feature will avoid compressor from
getting damaged due to low voltage.
Once voltage supply of fridge reaches
the desired level, it will automatically
start to run.
If your fridge is not operating;
 Is there any electrical faults?
 Is your appliance plugged?
 Is the fuse of the socket outlet that the plug is plugged or the main fuse blown?
 Is there any fault in the socket outlet? Examine this by plugging your fridge into a socket outlet which
you are sure that is working.
If your fridge is operating too loudly;
Normal
Noises
Cracking (Ice cracking) Noise:
 During automatic defrosting.
 When the appliance is cooled or warmed (due to expansion of appliance material).
Short cracking:
Heard when the thermostat switches the compressor on/off .
Compressor noise (Normal motor noise):
This noise means that the compressor operates normally Compressor may cause more noise for a short
time when it is activated.
Bubbling noise and splash:
This noise is caused by the fl ow of the refrigerant in the tubes of the system.
Water fl ow noise:
Normal fl ow noise of water fl owing to the evaporation container during defrosting. This noise can be
heard during defrosting.
Air Blow Noise:
Normal fan noise. This noise can be heard in No-Frost fridge during normal operation of the system due to
the circulation of air.
If the edges of fridge cabinet that the door joint contact are warm;
Especially in summer (hot weather), the surfaces that the joint contact may get warmer during the
operation of the compressor, this is normal.