Philco PC 455 Adora - Příručka (Stránka 8)

EN- 6
02/2015 Copyright © 2015, Fast ČR, a. s.
Installation and Operation of your Refrigerator
Before starting to use your fridge, you should pay attention to the following points:
 The operation voltage of your refrigerator is 220-240 V and 50 Hz.
 Our company shall not be held responsible for damages that may arise due to utilization with no grounding
installation.
 Place your refrigerator in a suitable spot that it will not be exposed to direct sunlight.
 It should be at least 50 cm away from heat sources such as cookers, ovens, wing radiators and stoves and
at least 5 cm away from electrical ovens.
 Your refrigerator should not be used in the open air and should not remain under the rain.
 If your refrigerator is juxtaposed with a deep freeze, it is necessary to leave a space
of at least 2 cm between them in order to prevent condensation on the outer
surfaces.
 Please do not place any heavy objects on your refrigerator and place your
refrigerator in a suitable spot in such a way that there will be a free space of
minimum 15 cm on the top.
 If your are going to place the refrigerator beside your kitchen cabinets then you
should keep a clearance of at least 2 cm’s between them.
 To prevent the condenser (the black backside component with fi ns) from touching
the wall, put on the plastic distance guide in its place rotating 90°.
 Refrigerator should be placed against a wall with a free distance not exceeding
75mm.
 To ensure smooth and vibration-free operation of your refrigerator, the adjustable
front feet must be set at the suitable height and mutually balanced. You can ensure
this by turning the adjustable feet clockwise (or counter-clockwise). This process
should be performed before the food is placed in the refrigerator.
 Before using your refrigerator, wipe all its parts with warm water in which you shall
add one teaspoon of food soda, then rinse it with clean water and dry it. After the
cleaning process is completed, place all the parts back.
 As the fl uid inside the cooler accumulator in the cooler door (see page 24, item
19) is chemical, accumulator door should not be damaged and the fl uid inside it
should not be drunk.
Before Starting to Operate Your Refrigerator
 During the fi rst operation or to ensure the effi cient operation of the device
following the relocation processes, allow your refrigerator to remain idle for 3 hours
(in a vertical position), then insert the plug to the socket. Otherwise, you may
damage the compressor.
 The fi rst time you operate your refrigerator, an odor might be smelt. This odor shall
disappear once your refrigerator starts cooling.