Philco PC 455 Adora - Příručka (Stránka 25)

EN - 23
02/2015 Copyright © 2015, Fast ČR, a. s.
If humidity builds up inside the fridge;
 Are all food packed properly? Are the containers dried before placing them in the fridge?
 Are the fridge doors opened frequently? Humidity of the room gets in the fridge when the doors are
opened. Humidity build up will be faster when you open the doors more frequently, especially if the
humidity of the room is high.
 Building up of water drops on the rear wall after automatic defrosting is normal. (in Static Models)
If the doors are not opened and closed properly;
 Do the food packages prevent closing of the door?
 Are the door compartments, shelves and drawers placed properly?
 Are door gaskets broken or torn?
 Is your fridge on a level surface?
If your fridge is not cooling enough;
See page 11. (Warning regarding temperature settings).
IMPORTANT NOTES:
 Compressor protection thermal fuse will be blown after sudden power breakdowns or after
unplugging the appliance, because the gas in the cooling system is not stabilized yet. Your
fridge will start after 5 to 10 minutes; there is nothing to worry about.
 If you will not use your fridge for a long time (e.g. in summer holidays) unplug it; and clean the fridge after
the defrosting procedure (see SECTION 4), and leave the door open to prevent humidity and smell.
 If the problem persists after you have followed all the instructions above, please consult to the
nearest Authorized Technical Service.
 The appliance you have purchased is designed for home type use and can be used only at home and
for the stated purposes. It is not suitable for commercial or common use. If the consumer use the
appliance in a way that does not comply with these features, we emphasize that the producer and
the dealer shall not be responsible for any repair and failure within the guarantee period.
Conformity Information
This equipment is designed for use at an ambient temperature within the 16°C - 43°C range.
The appliance is designed in compliance with the , IEC60335-1 / IEC60335-2-24, 2004/108/EC standards.
Recommendations for Energy Saving
 Place your appliance in a cool and well-ventilated room, avoid placing towards direct sunlight or near heat
radiators (radiator, oven, etc.). Otherwise, use insulation plate.
 Allow hot food and drinks to cool down outside the appliance.
 Place frozen food in refrigerator for thawing. When frozen food is thawed, its lower temperature will help
refrigerator cool down. Thus, energy will be saved. Putting frozen food outside will cause waste of energy.
 When putting drinks and homemade food into refrigerator, make sure that they are in an enclosed bowl.
Otherwise, humidity in the appliance will rise. This will make operation time longer. Preserving drinks and
homemade food in enclosed bowls will also avoid deterioration of odours and tastes.
 When putting drinks and food in the refrigerator, leave door of appliance open for some time as short as
possible.
 Keep compartments with diff erent temperature values in the appliance closed. (crisper, chiller
compartment, etc.)
 Door gasket should be clean and fl exible. Replace old gaskets.