Philco POB 79 - Příručka (Stránka 45)

8. Hold the door glass panels on their top
edge one by one and pull them up out
of the guide.
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
Installing the door and the glass
panels
When the cleaning is completed, install the
glass panels and the oven door. Do the
above steps in the opposite sequence. In-
stall the smaller panel first, then the larger.
WHAT TO DO IF…
Warning! Refer to the Safety chapters.
Problem Possible cause Remedy
The appliance does not heat
up. The appliance is deactivated. Activate the appliance.
The appliance does not heat
up. The clock is not set. Set the clock.
The appliance does not heat
up. The necessary settings are not
set. Control the settings.
The appliance does not heat
up. The fuse is released. Make sure that the fuse is the
cause of the malfunction. If the
fuse releases again and again,
contact a qualified electrician.
The lamp does not operate. The lamp is defective. Replace the lamp.
Steam and condensation settle
on the food and in the appli-
ance cavity. You left the dish in the appli-
ance for too long. Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking proc-
ess ends.
The display shows “12.00”. A power cut. Reset the clock.
If you cannot find a solution to the problem
yourself, contact your dealer or the service
centre. The necessary data for the service centre is
on the rating plate. The rating plate is on
the front frame of the appliance cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
INSTALLATION
Warning! Refer to the Safety chapters. Important! The built-in unit must meet the
stability requirements of DIN 68930.
17