Philco POB 62 - Příručka (Stránka 80)

A
A
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
3. Close the oven door to the first open-
ing position (approximately 70° angle).
4. Hold the door with one hand on each
side and pull it away from the appli-
ance at an up angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface. This
is to prevent scratches.
2
B
1
6. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
7. Pull the door trim to the front to re-
move it.
8. Hold the door glass panels on their top
edge one by one and pull them up out
of the guide.
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
Installing the door and the glass
panels
When the cleaning is completed, install the
glass panels and the oven door. Do the
above steps in the opposite sequence. In-
stall the smaller panel first, then the larger.
WHAT TO DO IF…
Warning! Refer to the Safety chapters.
Problem Possible cause Remedy
The appliance does not heat
up. The appliance is deactivated. Activate the appliance.
The appliance does not heat
up. The clock is not set. Set the clock. Refer to “Setting
and changing the time”.
The appliance does not heat
up. The necessary settings are not
set. Make sure that the settings are
correct.
The appliance does not heat
up. The automatic cut-out is activa-
ted. Refer to “Automatic switch-off”.
36